You can use a cheap lux meter to estimate the PAR intensity your plants are receiving. You can multiply a lux meter reading by a factor we have calculated to get an estimate of the PAR intensity in µmols/m²/second. The converted readings are not exact but good enough for a home grower to optimise their grow light setup.
Using a Lux meter for grow light setup
I have tested four cheap Lux meters from Amazon to see if they can be used to measure PAR (Photosynthetically Active Radiation). I have compared the results to a market leading par meters to see if you can use a lux meter to optimise your grow light setup.
The measurements are compared to the benchmark Apogee SQ500 quantum sensor which costs about $650. The results are surprisingly accurate.
Lux meter to PAR tests
The Lux meters were tested with the two most common spectrum in LED grow lights sold in the last few years, a 3500K or neutral white LED and a White LED with added red LEDs. Other grow light spectrum were not tested and thus hack will not work for HID or 'Blurple' led grow lights (with blue and red diodes only).
Each Lux meter reading was graphed against the benchmark quantum sensor readings. On the top of each chart is the factor to apply for each Lux meter to convert the lux readout to PAR in µmols/m²/sec.
For example if you are using the UNI-T lux meter and you have a white and red LED grow light you multiply the LUX readout by 0.017 for the PAR equivalent.
Buy the UNI-T UT383BT Lux meter here
Can a Lux meter be used to measure PAR for indoor growers?
Lux meter specs: Light meter AP-881E light meter for plants Illuminance meter Lux meters with Display 3999(Range from 1～300,000Lux Mastech MS6612 Lux 1 to 200000 Uni -T UT383 Lux meter V resourcing Lux meter 1 200000 lux
Buy the UNI-T UT383BT Lux meter here
Buy the UNI-T UT383BT Lux meter here
Buy the UNI-T UT383BT Lux meter here
6 thoughts on “Cheap PAR meter hack - Use a Lux meter to measure PAR accurately”
Vince milczewski
Hey bud, I bought the uni-t because I seen ur videos. After reading ur finding it says to take the LUX and multiply it by .017 I get. Avery low number and my park should be way higher. Do I multi lot by .17 or .017 because removing 1 decimal place seems to be a lot closer to what I was expecting? Thanks for any info u could give me. Your YouTube videos are very helpful, thanks!