MIGRO UVB Instruction manual
MIGRO UVB grow light
Follow us @migrolight #migrouv
Please read this manual thoroughly before assembling and installing the MIGRO grow lights system
Please retain this manual for reference for the lifetime for the product
To minimise risk please switch the power off while installing and adjusting the MIGRO system. If the mains plug needs to be changed to suit your power socket only a qualified person should carry out this work, in accordance with your local codes.
The UVB radiation from the light fixture can damage eyes and skin. Switch off the UVB grow light when in the grow room. Any object within 90cm or 3ft of the fixture in the direction of the radiation may be damaged over time (bleaching them for example).
Fluorescent tubes are delicate and may break during transit. If this is the case contact us and we will send a replacement immediately. Before you contact us please double check the bulb by turning it in the fixture to make sure good electrical contact is being made.
Fluorescent tubes will 'rattle'
The fluorescent tube will make a rattling noise. This is due to a small ball of mercury and other metals in the tube. These metals vaporize when powered up and emit the UV photons.
The light output may be wavey on initial startup
The mercury ball may lodge in the filament at the end of the tube. If there is waviness please wait for the fixture to warm up after a few minutes and tilt the fixture from side to side to move the metals around the tube for even illumination.
Attach the hanging clips to the light fixture, one on each end
- The aim is to stimulate the production of essential oils and increase potency. This is best achieved in the last 3 weeks of flowering.
- Set the control timer to switch the UVB light on for 1.5hours (45cm hanging height) to 2 hours (60cm hanging height) per light cycle
- If there is no noticeable plant damage (browning on leaf tips) then increase in 0.5 hour increments and check for damage again.
- Keep increasing to maximise the dosage until some browning or bleaching on the tips is observed than reduce the time by 0.5 hours
Light Fixture: AC100-277V 50/60HZ 0.6MM aluminum body, UV reflective aluminum reflector, electronic ballast, PF0.5CE/UL EMC, bodysize: 615*60*40mm reflector width: 60mm, 2M 2*0.75 cores cable, hanging: 2 x stainless hooks
Hanging height: 60cm (2ft”)
Light dimensions: 62cm long x 6cm wide and 5cm high (24″ x 2.5″ x 2″)
Power consumed: 22 watts
Voltage / Current: 110V / 1.1 Amp; 220V / 0.5 Amp
Spectrum: UVB 310 nm
Lifetime: 5,000 hours
Warranty: 1 year
Hanging weight: 300g (11 Oz)
Driver: 1 x T8 60cm or 2ft Fluorescent light fixture with UV reflective aluminum reflector
Cables: 2m cable
Plug: UK, US, Euro, Swiss or AUS plug options
Youtube: MIGRO channel – optimise your grow light setup